You can also subscribe without commenting.An automated Installer and Wizard are available to help with install, as well as manual instructions. Notify me of followup comments via e-mail. Save my name, email, and website in this browser for the next time I comment. Please keep in mind that all comments are moderated and your email address will NOT be published. Have a question or suggestion? Please leave a comment to start the discussion. We are thankful for your never ending support. Millions of people visit TecMint! If you like what you are reading, please consider buying us a coffee or 2 as a token of appreciation. TecMint is the fastest growing and most trusted community site for any kind of Linux Articles, Guides and Books on the web. We hope that everything worked on fine while following this guide, otherwise, use the feedback form below to send us your queries. You should be able to see a message indicating that PHP is installed and configured with the ioncube loader extension status should be enabledas shown in the following screenshot. To test if ionCube loader is now installed and properly configured on your server, check your PHP version once more. Now we need to restart the Apache or Nginx web server for the ioncube loaders to come into effect. Note : Make sure to replace the extension directory and PHP version in the above command according to your system configuration. Now we need to configure ioncube loader to work with PHP, in the php. Note : Make sure to replace the PHP version and extension directory in the above command according to your system configuration. Next we need to copy ioncube loader for our PHP 5. Next, find the location of the extension directory for PHP version 5. The above output clearly shows that the system is using PHP 5. To know the php version installed on your server, run the command.
There will be different ioncube loader files for various PHP versions, you need to select the right ioncube loader for your installed PHP version on your server. Then run the ls command to list the numerous ioncube loader files for different PHP versions. Then unzip the downloaded file using the tar command and move into the decompressed folder. The above output clearly shows that the system is running on bit architecture.
After installing Apache or Nginx with PHP on your system, start the web server and make sure to enable it to auto start at system boot time using following commands.
#Ioncube decoder wordpress install#
If you already have a running web server Apache or Nginx with PHP installed on your system, you can jump to the Step 2otherwise use the following yum command to install them. It is mostly used in commercial software applications to protect their source code and prevent it from being visible.